Atech Tech LIBRA-04 M Uživatelský manuál

LIBRA-04 M MANUAL COPY ROUTER LIBRA-04 M MANUAL COPY ROUTER User's Manual

LIBRA-04 M MANUAL COPY ROUTER 10 / 19 IV – INSTALLATION The Libra-04 M Manual Copy Router is factory tested to ensure that the electrical system a

LIBRA-04 M MANUAL COPY ROUTER 11 / 19 IV.2 – THE REQUIRED OPERATION ZONE ATech recommends a minimum of 100 cm (40”) clearance on the front, a minim

LIBRA-04 M MANUAL COPY ROUTER 12 / 19 Pressure for air should read 6 to 8 bar (90-120 psi). Using hose with a large diameter may pr

LIBRA-04 M MANUAL COPY ROUTER 13 / 19 V – RUNNING THE MACHINE Figure 5-1 Machine parts

LIBRA-04 M MANUAL COPY ROUTER 14 / 19 MILLING PROCESS Turn on the main power switch, put the profile onto the setsquare and clamp it with the c

LIBRA-04 M MANUAL COPY ROUTER 15 / 19 Electric cabinet should be cleaned from dust and shaving with air once in six months. • If clamp pistons

LIBRA-04 M MANUAL COPY ROUTER 16 / 19 If the machine seems like normal completely, read the user guide again by running the machine with the method

LIBRA-04 M MANUAL COPY ROUTER 17 / 19 VIII – CIRCUIT DIAGRAM VIII.1 – PNEUMATIC CIRCUIT

LIBRA-04 M MANUAL COPY ROUTER 18 / 19 VIII.2 –ELECTRIC CIRCUIT

LIBRA-04 M MANUAL COPY ROUTER 19 / 19

LIBRA-04 M MANUAL COPY ROUTER TABLE OF CONTENTS ITEM # SUBJECT PAGE # I INTRODUCTION 3 II SAFETY APPLICATIONS 4 II.1 DESCRIPTION O

LIBRA-04 M MANUAL COPY ROUTER 3 / 19 I. GENERAL INFORMATION 1.1. INTRODUCTION The user’s manual given by the manufacturer contains neces

LIBRA-04 M MANUAL COPY ROUTER 4 / 19 II – SAFETY APPLICATION Before operating this equipment, be sure of reading and understanding the

LIBRA-04 M MANUAL COPY ROUTER 5 / 19 This explains not be pulled up the protective parts. Do not operate without guards. This is high temperatur

LIBRA-04 M MANUAL COPY ROUTER 6 / 19 Use only original spare part. Don’t lean against control panel and do not force. Use e-Stop button w

LIBRA-04 M MANUAL COPY ROUTER 7 / 19 Disconnect electrical power hydraulic and air pressure before making repairs or adjustments. Do not run the

LIBRA-04 M MANUAL COPY ROUTER 8 / 19 III –MACHINE DESCRIPTION LIBRA-04 M Manual Copy Router is used for milling lock holes,